Brake Fluid

Honda Crosstour / Honda Crosstour 2010-2025 Owner's Manual / Maintenance / Maintenance Under the Hood / Brake Fluid

Specified fluid: Honda Heavy Duty Brake Fluid DOT 3

■Checking the Brake Fluid

The fluid level should be between the MIN

The fluid level should be between the MIN and MAX marks on the side of the reservoir.

NOTICE

Brake fluid marked DOT 5 is not compatible with your vehicle’s braking system and can cause extensive damage.

If the specified brake fluid is not available, you should use only DOT 3 or DOT 4 fluid from a sealed container as a temporary replacement.

Using any non-Honda brake fluid can cause corrosion and decrease the longevity of the system. Have the brake system flushed and refilled with Honda Heavy Duty Brake Fluid DOT 3 as soon as possible.

If the brake fluid level is at or below the MIN mark, have a dealer inspect for leaks or worn brake pads as soon as possible.

    See also:

    AhaTM
    If an error occurs while playing AhaTM, you may see the following error messages. If you cannot clear the error message, contact a dealer. ...

    HFL Menus
    The ignition switch must be in ACCESSORY or ON to use HFL. ■ Phone Settings screen 1. Press the DISP button. 2. Rotate to select Settings, then press . 3. Rotate to select Phone Se ...

    Windshield Wipers and Washers
    Windshield Wiper 1. MIST 2. OFF 3. INT Intermittent 4. LO Low speed 5. HI High speed 6. Windshield washers Push the right lever up or down to select a position. MIST - The wipers run at high ...