Changing the Rear Wiper Blade Rubber

Honda Crosstour / Honda Crosstour 2010-2026 Owner's Manual / Maintenance / Checking and Maintaining Wiper Blades / Changing the Rear Wiper Blade Rubber

1. Raise the wiper arm off.

1. Raise the wiper arm off.

2. Pry on the edge of the lock tab using a flattip

2. Pry on the edge of the lock tab using a flattip screwdriver to push it up.
- Wrap the flat-tip screwdriver with a cloth to prevent scratches.

3. Slide the wiper blade out from the end with

3. Slide the wiper blade out from the end with the indent.

NOTICE

Avoid dropping the wiper arm; it may damage the rear window.

4. Remove the retainers from wiper blade and

4. Remove the retainers from wiper blade and mount to a new rubber blade.

5. Slide the wiper blade onto the holder.

5. Slide the wiper blade onto the holder.
- Make sure it is engaged correctly, then install the wiper blade assembly onto the wiper arm.

    See also:

    Airbag Care
    You do not need to, and should not, perform any maintenance on or replace any airbag system components yourself. However, you should have your vehicle inspected by a dealer in the following situatio ...

    Cleaning the Seat Belts
    Dirt build-up in the loops of the seat belt anchors can cause the belts to retract slowly. Wipe the insides of the loops with a clean cloth dampened in mild soap and warm water or isopropyl alco ...

    Headlight Bulbs
    When replacing, use the following bulbs. High beam headlight: 60W (HB3) Low beam headlight: 55 W (H11) High Beam Headlight Driver's side 1. Remove the clips using a flat-tip screwdriver, the ...