Emissions Testing
Testing of Readiness Codes
Your vehicle uses “readiness codes,” as part of its onboard self diagnostic system. Some states refer to these codes during testing to see if your vehicle's emissions components are working properly. The codes may not be read if you go through the testing just after the battery has gone dead or been disconnected.
To check if they are set, turn the ignition switch to ON
, without starting the engine. The
malfunction indicator lamp will come on for several seconds. If it then goes off,
the readiness codes are set. If it blinks five times, the readiness codes are not
set.
If you are required to have your vehicle tested before the readiness codes are ready, prepare the vehicle for retesting by doing the following:
1. Fill the gas tank to approximately 3/4 full.
2. Park the vehicle and leave the engine off for 6 hours or more.
3. Make sure the ambient temperature is between 40°F and 95°F (4°C and 35°C).
4. Start the engine without touching the accelerator pedal, and let it idle for
20 seconds.
5. Keep the vehicle in . Increase
the engine speed to 2,000 rpm, and hold it there for about 3 minutes.
6. Let the engine idle with your foot off the accelerator for 20 seconds.
7. Select a nearby, lightly traveled major highway where you can maintain a speed
of 50 to 60 mph (80 to 97 km/h) for at least 20 minutes. Drive on the highway in
. Do not use cruise control. When
traffic allows, drive for 90 seconds without moving the accelerator pedal. (Vehicle
speed may vary slightly; this is okay.) If you cannot do this for a continuous 90
seconds because of traffic conditions, drive for at least 30 seconds, then repeat
it two more times (for a total of 90 seconds).
8. Drive in city/suburban traffic for at least 10 minutes. When traffic conditions allow, let the vehicle coast for several seconds without using the accelerator pedal or the brake pedal.
9. Park the vehicle and leave the engine off for 30 minutes.
Testing of Readiness Codes
The readiness codes are erased when the battery is disconnected, and set again only after several days of driving under a variety of conditions. If a testing facility determines that the readiness codes are not set, you may be requested to return at a later date to complete the test. If the testing facility determines the readiness codes are still not set, see a dealer.
See also:
TPMS (Tire Pressure Monitoring System)
Monitors the tire pressure while you are
driving. If your vehicle’s tire pressure becomes
significantly low, the low tire pressure
indicator comes on.
Conditions such as low ambient temperatur ...
Safety of Infants and Small Children
Protecting Infants
An infant must be properly restrained in a rear-facing, reclining child seat
until the infant reaches the seat maker's weight or height limit for the seat, and
the infant is ...
If the Engine Overheats
The reading of the vehicle’s temperature gauge should stay in the midrange. If
it climbs to the red mark, you should determine the reason (hot day, driving up
a steep hill, etc.).
If the vehicl ...